ABSTRACT
OBJECTIVE: The purpose of this study was to analyze the transverse dental compensation in reference to the maxillary and mandibular basal bones using cone-beam computed tomography (CBCT) and evaluate the correlations between transverse dental compensation and skeletal asymmetry variables in patients with skeletal Class III malocclusion and facial asymmetry. METHODS: Thirty patients with skeletal Class I (control group; 15 men, 15 women) and 30 patients with skeletal Class III with menton deviation (asymmetry group; 16 men, 14 women) were included. Skeletal and dental measurements were acquired from reconstructed CBCT images using OnDemand3D 1.0 software. All measurements were compared between groups and between the deviated and nondeviated sides of the asymmetry group. Correlation coefficients for the association between skeletal and dental measurements were calculated. RESULTS: Differences in the ramus inclination (p < 0.001), maxillary canine and first molar inclinations (p < 0.001), and distances from the canine and first molar cusp tips to the midmaxillary or midmandibular planes (p < 0.01) between the right and left sides were significantly greater in the asymmetry group than in the control group. In the asymmetry group, the ramus inclination difference (p < 0.05) and mandibular canting (p < 0.05) were correlated with the amount of menton deviation. In addition, dental measurements were positively correlated with the amount of menton deviation (p < 0.05). CONCLUSIONS: Transverse dental compensation was correlated with the maxillary and mandibular asymmetry patterns. These results would be helpful in understanding the pattern of transverse dental compensation and planning surgical procedure for patients with skeletal Class III malocclusion and facial asymmetry.
Subject(s)
Humans , Male , Compensation and Redress , Cone-Beam Computed Tomography , Facial Asymmetry , Malocclusion , MolarABSTRACT
OBJECTIVE: With the introduction of third-generation light-emitting diodes (LEDs) in dental practice, it is necessary to compare their bracket-bonding effects, safety, and efficacy with those of the second-generation units. METHODS: In this study, 80 extracted human premolars were randomly divided into eight groups of 10 samples each. Metal or polycrystalline ceramic brackets were bonded on the teeth using second- or third-generation LED light-curing units (LCUs), according to the manufacturers’ instructions. The shear bond strengths were measured using the universal testing machine, and the adhesive remnant index (ARI) was scored by assessing the residual resin on the surfaces of debonded teeth using a scanning electron microscope. In addition, curing times were also measured. RESULTS: The shear bond strengths in all experimental groups were higher than the acceptable clinical shear bond strengths, regardless of the curing unit used. In both LED LCU groups, all ceramic bracket groups showed significantly higher shear bond strengths than did the metal bracket groups except the plasma emulation group which showed no significant difference. When comparing units within the same bracket type, no differences in shear bond strength were observed between the second- and third-generation unit groups. Additionally, no significant differences were observed among the groups for the ARI. CONCLUSIONS: The bracket-bonding effects and ARIs of second- and third-generation LED LCUs showed few differences, and most were without statistical significance; however, the curing time was shorter for the second-generation unit.